Support
Support
Keeping kit earning
Support that starts with the machine in front of you
BrightFrame support is written for print rooms and CNC floors that already know the work. The aim is simple: keep wide-format printers, flatbeds and routing kit earning, instead of waiting on a service story with no date and no part number. We would rather have an ordinary photo of the carriage and a clear note about the last good job, than a long email that never names the model.
The six paths below cover the usual points where a shop gets stuck. Commissioning is for a new cell that still needs to prove itself on local power and media. A remote check is for the days when the printer is loaded and nobody can wait for a road trip. Parts support is for the roller, pump or cap-top that should have been on the shelf already. A training hour is for the operator who inherited a machine and has not been shown the media path properly. Escalation is for the fault that has already been around the floor once. Warranty support is for the cases that need the inspection and the paperwork lined up together.
None of these replace good housekeeping on the floor. Dust on the Highveld, salt air on the coast, and unstable supply around heaters and vacuum pumps will still show up as machine trouble first. Support goes better when those conditions are mentioned up front.

Commissioning
A clear commissioning process for South African print rooms and CNC floors, written for crews who already work the kit.

Remote Check
A practical remote check process for South African print rooms and CNC floors, written for teams who know the equipment.

Parts support
A straightforward parts supply process for South African print rooms and CNC floors, written for people who already run production.

Training Hour
A focused training hour for South African print rooms and CNC floors, built for operators and technicians who know the work.

Escalation
A clear escalation route for South African print rooms and CNC floors, written for teams handling faults under production pressure.

Warranty support
A practical warranty support process for South African print rooms and CNC floors, written for teams who need the paperwork and the fault details lined up.
How a call should run
What we ask for, and what you should get back
Send the floor, not just the fault
A full-machine photo plus a closer frame of the area that failed tells us more than a cropped sensor shot. Add the model, the media on the roll or table, and whether the job stopped mid-print or never started. The photo protocol sets out the frames that save a second round of questions.
Separate parts, training and warranty
A missing spare is not the same as an operator who has not been shown a daily clean, and neither is the same as a warranty inspection. Mixing them in one note slows everyone down. If you are unsure which path fits, say what happened in order and we will point the request, rather than forcing you to pick a label first.
Leave with a next step you can hand over
A useful support note can be read by the next person on shift: what was checked, what was ordered, what still needs a site visit. That is how print cells and care notes keep a shop moving when the original caller has already gone home.
- Model, media and a wide photo before panels come off
- One path for parts, training, remote checks or warranty
- A written follow-up through the contact form
When support meets the floor plan
Some calls turn into a layout conversation. If the printer is fine but the aisle, power drop or extraction is fighting the week, look at Floors and the project notes under Projects. Resources on care, power and safety sit beside this page so a team can read the same language we use on a visit.

