Resources

Warranty Note

A warranty note that sets out what to record on South African installations, servicing and fault cases before any claim is raised.

Where Warranty Note lands in a normal week

The Warranty Note page explains what to record during installations, servicing and fault cases before any warranty claim is raised. It helps South African workshops keep the right job notes, photos and machine details together from the start.

Record the exact model, serial number, install address, and the date the fault started. Add ink set, media type, cutter or spindle hours, and any recent part changes before a claim is logged. South African warranty cases often turn on site conditions such as dust, humidity, unstable supply, and transport damage after delivery.

Photograph the machine before covers come off or any cleaning begins. Include the control screen, fault code, damaged area, and the consumables fitted at the time of failure. A dated image set and a short service note usually prevent arguments about what was found on arrival.

Claim file essentials

A proper warranty note should show who attended, what tests were run, and which readings were taken. List replaced parts, firmware version, maintenance status, and whether the unit was under load when the issue appeared. That gives the supplier a usable record instead of a loose chain of calls and screenshots.

Link the note to the job card, service photos, and any courier paperwork if parts moved between sites. Before sending anything through the contact form, check that the machine ID plate, install town, and fault evidence are visible in the attachments. If a board, pump, or driver was removed, mark the package so the returned item matches the written report exactly.

  • Serial number and install site captured
  • Fault code shown before resets
  • Photos, readings, and replaced parts listed

Conditions that affect claims

Johannesburg dust, Durban humidity, and Cape Town salt air do not affect machines in the same way. Put those conditions in the warranty note together with the room setup, extraction status, and power protection in use. A flatbed near an open roller door needs a different inspection trail from a printer in a closed production room.

Load-shedding and generator changeovers must be noted when boards, drives, or PSU faults are suspected. Include breaker trips, UPS alarms, and whether the machine completed a shutdown cycle. For CNC calls, state the tooling fitted, hold-down method, and material being cut when the fault occurred.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

What to capture on site

Write down the complaint in plain words, then add what you observed during checks. Note nozzle state, vacuum readings, spindle noise, belt wear, rail condition, sensor status, and any recent operator changes. The stronger record is the one that separates confirmed facts from workshop guesses.

Log the warranty note on the same day as the visit while times, settings, and photos still line up. Attach it to the machine history so repeated faults on the same unit can be traced across installations, services, and call-outs. That paper trail matters when a supplier asks whether the issue is a defective part, site condition, or maintenance gap.