Resources
Spare List
A spare parts list focused on the items South African teams most often need on hand to keep printers and CNC machines moving.
When Spare List saves time in a service week
The Spare List page highlights the parts South African teams most often need to keep on hand for printers and CNC machines. It is a practical stock reference for workshops that want fewer stoppages when a common item fails or wears out.
Use the Spare List as a bench stock guide for the parts that stop work most often on large-format printers, flatbeds, and CNC equipment. Include the machine model, the failed item, and whether the stoppage happened during printing, vacuum hold, carriage travel, or spindle use. Conditions differ between Gauteng dust, Durban humidity, and Cape Town salt air, so storage and replacement habits matter.
Photograph the failed part in place before it is removed, especially if cable routing, sensor position, or hose length may matter. Add a note on what was fitted last, what was swapped to test, and whether the machine restarted or kept throwing the same fault. That record helps separate a worn consumable from a repeat electrical or air issue.
Parts worth keeping nearby
South African workshops usually need certain spares on hand for routine failures and wear points. Think fuses, dampers, belts, bearings, sensors, pumps, valves, collets, and small electronic items that can halt a printer or router. The aim is tighter stock control and fewer dead hours while waiting for a simple part.
Check part numbers against the label on the machine, not only against an older invoice or memory from a previous repair. Name the failed item through the contact form, then note any modifications such as aftermarket pumps, changed cabling, or non-standard tool holders. If the stoppage followed load-shedding, say whether the fault appeared at startup or during production.
- Common wear items for daily production
- Part numbers matched to machine labels
- Machine photos with failed part detail
Stock decisions shaped by SA conditions
Spares planning changes when a site depends on overnight freight from Johannesburg or a courier run out of Durban or Cape Town. A workshop in a smaller town may need a deeper shelf of service items than a city print room with easier collections. Keep that in mind when deciding whether one spare is enough or whether two should be on hand.
Humidity can shorten the life of boards, connectors, and some sensors if storage is poor. Fine dust affects rails, fans, encoder strips, and vacuum systems, while unstable power can take out fuses, power supplies, and motion electronics. Store critical items sealed, labelled, and away from heat so they are usable when a stop happens.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
What to send with requests
Send the spare list with photos of the machine, timing for the stoppage, and a practical note on what has already failed or been swapped out. Use a subject line that names the parts or fault.
When asking about a part, send the machine nameplate photo, the spare number if visible, and clear images of the failed area. Add a short note on the symptom, any alarm code, and what was replaced or tested before the machine stopped again. For CNC equipment, mention spindle type, tooling setup, and whether vacuum hold or dust extraction was affected.

