Resources

Media Guide

Media handling guidance for South African sign floors, from roll storage and sheet loading to print-side checks and clean feeding.

How Media Guide helps on a busy production week

The Media Guide page explains media handling on sign floors, from roll storage and sheet loading to print-side checks and clean feeding. It is useful where poor storage or rough handling keeps causing skew, marks or wasted stock.

When you send a media query, note the printer model, the material name, the width or sheet size, and where the fault shows up. Conditions differ between Gauteng dry air, Durban humidity, and Cape Town winter damp, so storage and handling advice must match the site. South African sign production uses rolls, boards, flatbeds, and print-and-cut setups, and each one needs the right handling.

Photograph the pallet, roll ends, or sheet stack exactly as found before wrapping is removed or corners are trimmed. Include labels, batch markings, and any visible crush, edge damage, or telescoping. Those details help separate a handling issue from a feed problem, head strike, or coating defect.

Roll stock, sheets, and print side

You can apply it to self-adhesive vinyl, banner, PET film, paper, foam PVC, ACM, and corrugated board. The aim is less skew, fewer rub marks, and cleaner feeding through the run.

Include photos that show the material in storage, on the spindle, or at the flatbed edge before printing starts. If you send details through the contact form, include the printer model, media brand, width, liner or face description, and whether the trouble is curl, strike, tracking, or poor hold-down. Add one image of the loaded setup and one close shot of the defect.

  • Roll storage that limits edge damage
  • Sheet loading checks before first print
  • Material notes sent with clear photos

Storage conditions across South Africa

Media behaviour changes with climate and warehousing. Inland stock can dry out and hold static, while coastal material may arrive with more curl, liner movement, or moisture-related adhesion trouble. The guide covers what to check before blaming profiles, heaters, vacuum zones, or pinch settings.

Dust around roll racks, cutting tables, and board stacks can transfer straight onto prints or into feed systems. Power interruptions also matter, especially when heaters cool down mid-run or vacuum drops during board placement. For that reason, the checks include media surface condition, edge cleanliness, and whether the stock sat wrapped or exposed overnight.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Useful details to send with media faults

Share the media guide with photos of the stock in use, run timing, and details of any feed, strike, curl, or adhesion trouble already seen. Keep the subject line true to the material problem.

Report the exact material, thickness or gsm, print mode, and whether the issue starts at leading edge, trailing edge, or across the full width. Mention if the same stock ran well before, if only one roll is affected, and whether the print side was confirmed before loading. That record makes the guide far easier to apply to the next test.