Frames
Take Up Kit
A take-up kit keeps printed media under control as the roll builds during long runs. On eco-solvent, UV and latex machines, the right tension and alignment reduce edge drift, scuffing and telescoping at the core.

Roll winding under production load
Take Up Kit covers the hardware that keeps printed media collecting neatly during production. It is useful on roll-fed machines where poor winding leads to skew, rubbing or wasted output near the end of a job.
Check the printer model, media width and core size before fitting any take-up hardware. Vinyl, banner, paper and film each pull differently, and a setting that tracks on one stock can crease another by the last few metres. Dusty inland shops and humid coastal sites also change how firmly the roll holds shape.
Look at the first wraps on the core, not only the print at the platen. If the roll starts off-centre, the problem usually grows as diameter increases and shows up as rubbing on guards or wandering at the edges. A quick note on tension, direction and shaft position helps the next operator repeat the setup.
Parts that affect neat rewinds
The useful checks are mechanical, not decorative. Shafts, collars, drive belts, clutches, sensors and core grips must match the machine and the weight of the media being collected. When any one of those is worn or loose, the output can finish skew even if the print itself looked fine at the start.
Use the contact form if the take-up side is causing waste near the end of a run. Include the printer model, media type, print direction, and whether the roll is tightening, loosening or walking sideways. Say how the first few wraps sit on the core as well.
- Core size checked before loading
- Tension set for media weight
- Sensor and clutch condition noted
Winding conditions across SA sites
Long banner runs in Johannesburg can build static and attract dust onto the winding side. In Durban and Cape Town, moisture in the air can soften some stocks and change how tightly they wrap on the core. That is why take-up settings need checking on site conditions, not only from a manual value.
Power interruptions matter when a roll is half built and heavy on the spindle. After a stop, inspect media tracking, pinch points and the lay of the wrap before restarting at production speed. On older sign shop equipment, worn bushes or a tired motor can show up only once the roll gains weight.
Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.
What to record on site
Note the machine model, media width, core diameter and whether winding is face-in or face-out. Add the point in the job where skew starts, plus any rubbing marks on covers, rollers or side plates.
A useful record also includes print mode, heater settings where fitted, and whether the issue appears on every roll or only certain materials. When buyers or operators need traceable information, that detail makes it easier to separate media behaviour from a hardware fault.
What our Large-Format Print customers say
Verified Google reviews

