Specs

Dryer Assist specs

Setup notes and briefing numbers for Dryer Assist.

Drying limits by media set

Dryer Assist specs breaks down the technical side of the drying support. Print teams get a straightforward view of the setup points, compatibility and operating details involved.

Dryer Assist specs focuses on the heat and airflow points that affect curing on solvent, eco-solvent, UV and latex output. It helps a print team match dryer support to the media width, ink laydown and line speed being used. Conditions in Gauteng differ from Durban and Cape Town, so ambient temperature and humidity belong in the setup notes.

Record the heater readings and fan settings before changing profiles or swapping rolls. A photo of the panel, the media label and the printed result gives a solid reference for later checks. That matters when edge curl, soft ink or blocking only shows up after the take-up reel has done a few metres.

What the spec sheet covers

The operating figures a shop needs before fitting or adjusting drying support on a large-format printer include compatible printer types, power demand, airflow direction, heat range and clearance around the print zone. These details make setup choices easier to compare against the machine standing on site.

Use Dryer Assist specs with the matching machine notes before you order parts or move a unit between print areas. Check the printer model, available power, media type and exhaust route against the actual installation. Printer and flatbed faults are easier to read from a photo of the print path and the error shown on the control panel.

  • Heat range matched to ink system
  • Airflow checked across full media width
  • Power and plug details noted

Site conditions that alter drying

Drying performance changes with room temperature, extraction quality and the way rolls are stored before printing. Shops near the coast often need closer attention to moisture on media, while inland sites deal with fine dust settling around fans and heater intakes. Older buildings also need a proper look at circuit load before any extra heating hardware is added.

Load-shedding and generator changeover can affect heater recovery and fan behaviour during long print runs. After a power event, recheck setpoints, substrate feed and the first printed panels instead of assuming the previous profile still holds. On busy sign sites, that quick inspection can prevent tunnelling, offsetting and half-cured ink on packed work.

Operated by Astros Marketing (Pty) Ltd from 2 Makro Place, Sunnyrock 1401.

Information needed before setup

Send the printer make and model, media being run, usual pass mode and the fault showing on output. Include whether the issue appears as tacky ink, mottling, curl, odour build-up or poor adhesion after finishing.

Add the available supply voltage, plug type and any extraction equipment near the printer. It also helps to note the room climate, recent profile changes and whether the problem starts at the leading edge or later in the run.

What our Large-Format Print customers say

Verified Google reviews